The TR690 CVT, also known as the Subaru Lineartronic, has been produced in Japan since 2009. The first version of the gearbox was intended for naturally aspirated engines up to 250 Nm of torque; later, a reinforced version appeared for turbocharged engines up to 400 Nm.
Specifications
| Type | continuously variable transmission |
| Number of gears | ∞ |
| Drive type | front / all wheel |
| Engine displacement, L | up to 2.5 |
| Max torque, Nm | up to 250 |
| Recommended oil | Subaru CVT Oil Lineartronic |
| Oil capacity, L | 12.5 |
| Partial oil change, L | 7.5 |
| Service interval | every 60 000 km |
| Service life, km | ~250 000 km |
Gear ratios Subaru TR690
Gear ratios for the 2010 Subaru Outback with a 2.5-liter engine:
| Final drive | 3.9 |
| Variator range | 3.525 – 0.558 |
| Reverse | 2.358 |
Applications
The transmission was installed on:
- Subaru Ascent 1 (WM) since 2018;
- Subaru Exiga 1 (YA) in 2009 – 2011;
- Subaru Forester 4 (SJ) in 2012 – 2018;
- Subaru Forester 5 (SK) in 2018 – 2024;
- Subaru Levorg 1 (VM) in 2014 – 2020;
- Subaru Levorg 2 (VN) since 2020;
- Subaru Legacy 5 (BM) in 2009 – 2014;
- Subaru Legacy 6 (BN) in 2014 – 2019;
- Subaru Legacy 7 (BW) since 2019;
- Subaru Outback 4 (BR) in 2009 – 2014;
- Subaru Outback 5 (BS) in 2014 – 2020;
- Subaru Outback 6 (BT) since 2020;
- Subaru WRX 1 (VA) in 2014 – 2021;
- Subaru WRX 2 (VB) since 2021.
Disadvantages of the Subaru TR690 gearbox
- In early torque converters, the thrust bearing was a phenolic washer that quickly wore into the turbine wheel hub, creating play. The aluminum oil supply tubes to the chain also did not last long and were replaced with plastic ones;
- This gearbox needs regular fluid changes, as the fluid quickly becomes contaminated with clutch wear debris, especially from the torque converter clutch lining. This debris damages the valve body solenoids, which sometimes fail by 150,000 km;
- Despite its impressive appearance, the chain in this CVT has a limited service life that depends heavily on how the car is used: hard starts, wheelspin, and similar abuse. With aggressive driving, the chain stretches and needs replacement before 150,000 km;
- Regular overheating significantly shortens the life of many components, bearings (especially on the drive shaft) often begin humming at high mileage, and frequent wheelspin quickly burns out the transfer case clutches;
- The manufacturer rates the TR690 service life at 250,000 km, but it can last up to 300,000 km.
Frequently asked questions about the Subaru TR690
What type of transmission is the Subaru TR690?
The Subaru TR690 is a continuously variable transmission for front-wheel and all-wheel drive cars.
How much torque can the Subaru TR690 handle?
The Subaru TR690 is designed for torque up to 250 Nm and engines up to 2.5 liters.
How much oil does the Subaru TR690 take and which one?
The Subaru TR690 takes 12.5 liters of oil (7.5 liters for a partial change). Recommended oil: Subaru CVT Oil Lineartronic.
How often should the Subaru TR690 be serviced?
Recommended service interval: every 60 000 km.
How long does the Subaru TR690 last?
With proper maintenance, the Subaru TR690 typically lasts about 250 000 km.
What are the gear ratios of the Subaru TR690?
Gear ratios for the 2010 Subaru Outback with a 2.5-liter engine: final drive 3.9, Variator range 3.525 - 0.558, reverse 2.358.
What cars was the Subaru TR690 installed on?
Subaru Ascent 1 (WM) since 2018; Subaru Exiga 1 (YA) in 2009 – 2011; Subaru Forester 4 (SJ) in 2012 – 2018; Subaru Forester 5 (SK) in 2018 – 2024; Subaru Levorg 1 (VM) in 2014 – 2020; Subaru Levorg 2 (VN) since 2020 and 8 more (see the full list above).
What are the common problems of the Subaru TR690?
In early torque converters, the thrust bearing was a phenolic washer that quickly wore into the turbine wheel hub, creating play. The aluminum oil supply tubes to the chain also did not last long and were replaced with plastic ones. This gearbox needs regular fluid changes, as the fluid quickly becomes contaminated with clutch wear debris, especially from the torque converter clutch lining. This debris damages the valve body solenoids, which sometimes fail by 150,000 km. All known problems.





